Creating a TunerStudio Project



TunerStudio Projects:

To present raw binary data found in the controller in an easy to read and edit fashion, TunerStudio must relate the information in several key files. To accomplish this TunerStudio uses a project. This project will tie together the firmware ini file(s), your settings, any inc files specific to your setup along with your dashboards and preferences and settings for TunerStudio.

Note: TunerStudio does have the capability to open an msq without a project, this handy feature allows you to quickly view settings from any msq you may have down loaded or gotten from a friend. However, TunerStudio does this by creating a temporary project and will not enable communications. You should always create a project if you are going to connect to and configure a controller.


Creating a Project

A project is created in few simple steps. Start by opening the "New Project" Dialog.
From the main menu:
File --> "New Project"
or
Press CTRL+N
The "New Project" Dialog will appear.


Page 1:


Page 2 (Project Settings):


Page 3 (Comm Settings):


Page 4 (Dash Board Selection):


Finish:


©2010 EFIAnalytics.com